Emergency Keys; Ways Of Disarming; Event Log Review; Alarm Clearing - SECOLink MAS-800 Short User Manual

Intruder alarm system
Table of Contents

Advertisement

Intruder alarm system

Emergency keys

In order to call for a help (the premises must be secured by CMS) press at once two specific keys and hold
them at least 1 second. When emergency alarm occurs, siren starts to sound and alarm message will be
shown on the keypad display.
ž
Fire alarm
ž
Medical alarm –
ž
Panic alarm

Ways of disarming

Disarming can be done by three ways: F-key, entering PIN code, Via Main Menu. Using F-key or entering PIN, all
partitions, which are controlled by User, will be disarmed. After disarming via Menu it's necessary to unmark the partition,
which we don't want to protect. The partition, which will be disarmed, is denoted the
by pressing the
key.
ENT
Disarming by PIN code, when entering the premise
After opening the door, which are protected, the system begins to count the entry delay. During this time it is
necessary to enter PIN code and confirm by pressing the
User, will be disarmed.
Disarming by PIN code, when staying in protected premise
When all partitions are armed and the entry door weren't opened, after entering PIN, all partitions, which
are controlled by User, will be disarmed. Disarming:
When part of partitions are armed and the entry door weren't opened, after entering PIN it is necessary to
make decision either to arm disarmed partitions or to disarm armed ones.
Full disarming :
Partial disarming:
Disarming when staying in protected premise – BB or F0
Nevertheless, are there all partitions armed or not, all partitions, which are controlled by User, will be
disarmed. Disarming :
ž
F-key:
The first partition disarming, when staying in premise - B1
Nevertheless, are there all partitions armed or not, the first partition, which is controlled by User, will be
disarmed. Disarming:
ž
F-key:
The second partition can be disarmed with

Alarm clearing

If an alarm has occured, on the display appears message "Alarm
caused it. Alarm LED is turned on, the siren starts to sound and report about alarm is sending to CMS or to
the User.
alarm
ž
1
way – pressing the
armed
After performed alarm clearing action siren stops to sound
the same as was before alarm. If the system has smoke detector and alarm was caused by smoke, which
trouble
was raised by domestic reasons, the system will start alarm, nevertheless it was armed or disarmed. The
only way to clear alarm is possible by bypassing of smoke detector (see
3
CLR
ž
2 way
After performed alarm clearing action siren stops to sound, alarm LED goes off, the system will be disarmed
if it was armed before entering PIN code. When all partitions, which are controlled by User, are disarmed, it's
not recommended to use PIN for alarm clearing, because is possible casual arming.
Event log review – F30, F31
All events, which are concerned with protected premises and status of the system, are stored in the event
log. Reviewing event log:
ž
F-key:
ž
Via Menu:
To display time or date event press the
Electronic notebook (memo) review - F09
al arm
armed
All important contact information
pre-alarm
trouble
ž
F-key:
ž
Via Menu:
+
.
A
1
+
.
B
4
+
.
C
7
, [Disarming]
PIN:
ENT
, [Disarming]
PIN:
ENT
or
F
0
ENT PIN:
ENT
.
B
1
ENT PIN:
ENT
There are 2 ways to clear alarm and turn off red LED:
CLR PIN:
– entering PIN code.
(ALARMS events),
F
3
0
ENT
ENT
, [
1 record
ENT
F
0
9
[memo
ENT
ENT
PIN:
, [All partitions]
ENT
, [Selected parti]
ENT
.
B
B
ENT PIN:
ENT
, both partitions with
B
2 2 2 2
.
ENT
F
3
[Event Log]
ENT
key
, next event is selected
(phone No, e-mail) Installer can write out on keypad. Review:
]
, [
2 record
]
, [
3 record
, [
1 record]
, [
2 record]
or
keys and this action is confirmed
key. All partitions, which are controlled by
ENT
.
ENT
.
ENT
, [Parts:]
ENT
.
B
1
2 2 2 2
!!!" with an explanation, what reason
, alarm LED goes off, the system status remains
2 page,
"Bypassing zone – B").
(FAULTS events).
1
ENT
, [Alarm Event]
, [PIN:]
ENT
the
,
]
, [
4 record
]
, [
, [
3 record
]
, [
4 record
Short user manual
.
ENT
.
PIN:
ENT
.key
5 record
]
.
]
, [
5 record
]
.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAS-800 and is the answer not in the manual?

Questions and answers

Ahmed
February 6, 2025

Comment changer les numéros de contact en cas d'alarme

Najih
April 3, 2025

In the panel of Secolink MAS-800 we see: Default KRBus tél .Service !

User image 67ef16e878402

Table of Contents