What To Do If - Electrolux EWC 1050 User Manual

• Select a wash programme, start the ma-
chine and let the programme run for a
short time.
• Interrupt the programme by turning the
programme selector to
• Place the end of inlet and drain hoses
down low, into the waste gully (floor drain)
set into the floor. Make sure that the end
of the hose does not go below the water
level in the gully's (drain's) water tap.

What to do if...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that
the End pilot light blinks to indicate that the
machine is not working:
Problem
The machine does not start:
The machine does not fill:
The machine fills then emp-
ties immediately:
The machine does not emp-
ty and/or does not spin:
• Select the programme "Drain" and let it run
• Turn the programme selector to
position.
The appliance is only to be used and stored
indoors at normal room temperature. The
manufacturer is not responsible for any frost
damage.
• 1 flash: problem with the water supply.
• 2 flashes: problem with the water drain-
• 4 flashes: door open.
Once the problem has been eliminated,
press the button START to restart the pro-
gramme. If after all checks, the problem per-
sists, contact your local Service Centre.
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button Start has
not been pressed.
• Please turn the selector dial and press the button Start again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
• Clean the water inlet hose filter.
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Installation» chapter.
The drain hose is squashed or kinked.
• Check the drain hose connection.
An option or a programme that ends with the water still in the tub or
that eliminates all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
until it is finished.
tion. When you intend to start the machine
up again, make sure that the room tem-
perature is above 0 °C.
ing.
Possible cause/Solution
electrolux 15
posi-