Using The Status Led To Troubleshoot System Problem; Error Codes; Ac/Dc 1000 ® Sd - Lincoln Electric power wave ac/dc 1000 sd Operator's Manual

E-2
Observe all Safety Guidelines detailed throughout this manual
USING THE STATUS LED TO TROUBLESHOOT
SYSTEM PROBLEMS
The Power Wave
mounted status light. If a problem occurs it is important to note the
condition of the status lights. Therefore, prior to cycling power to
the system, check the power source status light for error
sequences as noted below.
Included in this section is information about the power source Status
LED and some basic troubleshooting charts for both machine and
weld performance.
The STATUS LIGHT is a dual-color LED that indicates system errors.
Normal operation is steady green. Error conditions are indicated in the
following Table E.1.
Light
Condition
Steady Green
Blinking Green
Fast Blinking Green
Alternating Green and Red
Steady Red
Blinking Red
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
TROUBLESHOOTING
® AC/DC 1000 ® SD is equipped with one externally
TABLE E.1
System OK. Power source is operational, and is communicating normally with all healthy
peripheral equipment connected to its ArcLink network.
Occurs during power up or a system reset, and indicates the POWER WAVE
is mapping (identifying) each component in the system. Normal for first 1-10
seconds after power is turned on, or if the system configuration is changed
during operation.
Under normal conditions indicates Auto-mapping has failed. Also used by
Weld Manager and Submerged Arc Cell Setup (available at www.power-
wavesoftware.com) to identify the selected machine when connecting to a
specific IP address.
Non-recoverable system fault. If the Status lights are flashing any combination
of red and green, errors are present. Read the error code(s) before the
machine is turned off.
Error Code interpretation through the Status light is detailed in the Service
Manual. Individual code digits are flashed in red with a long pause between
digits. If more than one code is present, the codes will be separated by a
green light. Only active error conditions will be accessible through the Status
Light.
Error codes can also be retrieved with Weld Manager under System Status
(available at www.powerwavesoftware.com). This is the preferred method,
since it can access historical information contained in the error log.
To clear the active error(s), turn power source off, and back on to reset.
Not applicable.
Not applicable.
CAUTION
POWER WAVE ® AC/DC 1000
Meaning
® SD
E-2
®