Diving – Vsi - xDEEP BLACK EANX User Manual

DIVING – MAIN SCREEN 2/2
attention! If you begin the dive breathing a gas other than the
primary one, remember to switch the gas immediately after going
into water. If you fail to do it, the device will include in the calcula-
tions another gas than the one you are actually breathing, which
as a result may lead to incorrect calculation of decompression
while diving with the BlaCK eanX in Gauge mode (BT), you can select one of
three layouts of the main screen: full, simplified and minimal. The layouts differ
from one another in terms of the amount of displayed information.
FUll
In order to configure the layout of the main screen, select in menu:
Settings >> Layouts >> Main screen
In the aIr, eanx and adv. eanx modes dive time and ceiling are
shown also in simple and minimum layout.
26
sImPle mInImUm
DIVING – VSI
The state-of-the art VsI indicator provides accurate buoyancy control and both
ascent and descent speed. It displays not only the current speed rate in meters
per minute, but also shows the rate in relation to the set optimal and max.
speed. The VsI indicator is displayed on the main screen and compass screen,
to their left.
when maintaining neutral buoyancy, the indicator does not deflect to any
direction. when you start descending or ascending, the indicator will deflect
appropriately down or up. The deflection volume corresponds to the descent or
ascent rates.
OPTImal asCenT raTe leVel
GraPHIC InDICaTOr OF CUrrenT asCenT/DesCenD sPeeD.
9
asCenT Or DesCenT raTe In m/mIn.
OPTImal DesCenT raTe leVel.
The indicator colour depends on ascent/descent rate: standard colour corre-
sponding to the range from zero to optimal rate; warning colour corresponding
to the rate exceeding the optimal one, and alarm colour corresponding to the
rate exceeding the max. one.
attention! Too fast ascent may cause decompression disease
(DCs). Before diving always check correct speed settings for VsI
indicator!
27