Cleaning The Gloss Cooktop - GE PGP9830 Owner's Manual & Installation Instructions

Cleaning The Cooktop
Control Knobs
The control knobs may be removed for easier cleaning.
Make sure the knobs are in the OFF positions and pull
them straight off the stems for cleaning.
To clean the knobs, place them in a dishwasher or wash
with soap and water. Rinse with clean water. Make sure
the insides of the knobs are dry before replacing.
Replace the knobs in the OFF position to ensure proper
placement.
Molded flat area
The control knobs may be removed
for easier cleaning.
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
To inquire about purchasing cleaning products including
stainless steel appliance cleaner or polish read the
Assistance / Parts and Accessories sections at the
beginning of this manual.
Cleaning the Glass Cooktop
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE ® Ceramic Cooktop
Cleaner on the glass cooktop. Other creams may not
be as effective.
To maintain and protect the surface of your glass
cooktop, follow these steps:
1. Before using the cooktop for the first time, clean it
with CERAMA BRYTE ® Ceramic Cooktop Cleaner.
This helps protect the top and makes cleanup easier.
2. Daily use of CERAMA BRYTE ® Ceramic Cooktop
Cleaner will help keep the cooktop looking new.
3. Remove the burner grates, vent grille and vent grille
gasket.
4. Shake the cleaning cream well. Apply a few drops of
CERAMA BRYTE ® Ceramic Cooktop Cleaner directly
to the cooktop.
5. Use a paper towel or
CERAMA BRYTE ® Cleaning
Pad for Ceramic Cooktops
to clean the entire cooktop
surface.
6. Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that
you DO NOT heat the cooktop
until it has been cleaned
thoroughly.
Clean your cooktop after each
spill. Use CERAMA BRYTE ®
Ceramic Cooktop Cleaner.
Burned-On Residue
NOTE: DAMAGE to your glass surface may occur if you
use scrub pads other than those recommended.
1. Allow the cooktop to cool.
2. Remove the burner grates, vent grille and vent grille
gasket. Spread a few drops of CERAMA BRYTE ®
Ceramic Cooktop Cleaner to the entire burned
residue area.
3. Using the included CERAMA BRYTE ® Cleaning Pad
for Ceramic Cooktops, rub the residue area, applying
pressure as needed.
4. If any residue remains, repeat the steps listed above
as needed.
,
For additional protection, after all residue has
been removed, polish the entire surface with
CERAMA BRYTE ® Ceramic Cooktop Cleaner
and a paper towel.
®
Use a CERAMABRYTE Cleaning
Pad for Ceramic Cooktops.
th
:1>
I'TI
:I>
th
r'-
I"1"1
:1>
Z
!
ii •
Cb
CD
Q
CD
O
©
©
-O
N
CD
Q
r_
CD
Q
N
©
O
©
-O