GE Profile PGP9830DJ Dimensions And Installation Information

PGP9830DJ/TJ
GE Profile Series 30" Downdraft Gas Cooktop
™
DIMENSIONS AND INSTALLATION INFORMATION
WALL INSTALLATION: Wall installations
require 25" countertop depth. When cabinet
is flush against the wall, the fan housing can
be rotated to the horizontal position for direct
venting through rear wall. Make a countertop
cutout in the range cabinet according to unit
dimensions and installation type. Duct hole is
positioned in back of cabinet for through-the-
wall ducting.
PENINSULA OR ISLAND INSTALLATION:
For peninsula/islands a minimum 26"countertop
depth is suggested. Blower should be in vertical
position. Island or peninsula cabinets may
require adjustment in cutout depth and/or
location within the width dimensions. Duct hole
is positioned in bottom of cabinet for island or
peninsula installation.
SLAB INSTALLATION: For peninsula or
island installation and rear wall ducting, 6" PVC
duct or locally approved piping should be used
if installing under a poured concrete slab.
INSTALLATION INFORMATION: Before
installing, consult installation instructions,
packed with product, for current dimensional
data.
NOTE: These cooktops are approved for indoor
use only.
For answers to your Monogram, GE Café
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
Cut-out Dimensions (in inches)
25
*U.L. Requirement.
Note: A 5" minimum spacing to adjacent side wall is required
25
*U.L. Requirement.
Note: A 5" minimum spacing to adjacent side wall is required
™ Series, GE Profile ™ Series or
® Service, 800.626.2000.
21 ⁄
7 ʺ 29 ⁄
3 ʺ
8
4
(21 ⁄ ʺ SS)
15 (29 ⁄ ʺ SS)
13
1 6
1 6
22ʺ
21 ⁄
7
ʺ
8
(21 ⁄ ʺ SS)
15
1 6
20 ⁄
1 ʺ
2 28 3 ⁄
ʺ
4
22ʺ
20 ⁄
1
ʺ
2
20-5/8
Cut-out Dimensions (in inches)
28-7/8
20-5/8
1-7/8"
MIN. Required*
1-7/8"
MIN. Required*
*NOTE: A 5" minimum spacing to adjacent side wall is required
Dimension and installation information are shown in inches.
2 ⁄
3 ʺ
16
(2 ⁄ ʺ SS)
1
4
29 ⁄
3 ʺ
4
(29 ⁄ ʺ SS)
13
1 6
28 ⁄
3 ʺ
4
9
C L
4
16
20
28-7/8
Specification Revised 4/16
2 ⁄
3
ʺ
16
(2 ⁄ ʺ SS)
1
4
10-1/2
Listed by
Underwriters
Laboratories