GE PGP9830 Owner's Manual & Installation Instructions page 23

Installation Instructions
POWER SUPPLY LOCATIONS
E] GAS SUPPLY:
These cooktops are designed to operate on natural gas at
4" of water column pressure or on LPgas at 10" of water
column pressure.
• These cooktops are shipped from the factory set for
natural gas. If you decide to use this cooktop with LP
gas, conversion adjustments must be made by a service
technician or other qualified person.
• The pressure regulator must be connected in series with
the manifold of the cooktop and must remain in series
with the supply line regardless of type of gas being used.
For proper operation, the maximum inlet pressure to
the regulator must be no more than 10" water column
pressure for natural gas and 14" water column pressure
for LPgas.
• When checking the regulator, the inlet pressure must be
at least 1" greater than the regulator output setting. If
the regulator is set for 4" of water column pressure, the
inlet pressure must be at least 5". If the regulator is set
for 10" of water column pressure,the inlet pressure must
be at least 11". For ease of installation, and if local codes
permit, the gas supply line into the cooktop should be 1/2"
or W' ID flexible metal appliance connector, three to five
feet long.
NOTE:Purchase a new flexible line. DO NOT USEAN OLD
PREVIOUSLY U SEDLINE.
• Hake gas connection through rear wall, or on cabinet floor
at rear, as illustrated.
r_ ELECTRICAL SUPPLY:
I
Electrical
outlet !2"
above cabinet
floor (mount
on side or
back cabinet
wall 2"min.
from
centerline)
4" (to clear toe kick area)
The built-in gas downdraft cooktop features pilotlesselectric
ignition for energy savings and reliability. It operates on a
120-volt, 60-Hz power supply.A separate circuit, protected
by a 1S-amp time-delay fuse or circuit breaker, is required.
• A properly grounded 3-prong receptacle should be located
within reach of cooktop's four foot power cord.
IMPORTANT: ( Please read carefully.} FORPERSONAL
SAFETY, THISAPPLIANCE MUSTBE PROPERLY GROUNDED.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a standard
three-prong grounding wall receptacle to minimize the
possibility of electric shock hazard from this appliance.
The customer should have the wall receptacle and circuit
checked by a qualified electrician to make sure the
receptacle is properly grounded and has correct polarity.
Where a standard two-prong wall receptacle is
encountered, it isthe personal responsibility and obligation
of the customer to have it replaced with a properly
grounded three-prong wall receptacle.
Do Not, Under Any Circumstances, Cut Or Remove The
Third (ground} Prong From The Power Cord,
Do not use an extension cord,
!
Z
¢D
r'-
r'-
!
O
Z
!
Z
--I
C
-4
!
O
Z