Neato Robotics Botvac User Manual page 24

TM
The left wheel is
M y L e f t W h e e l
stuck and the robot is
i s s t u c k .
experiencing mobility
P l e a s e f r e e
problems.
i t f r o m
d e b r i s .
Botvac was picked up.
P l e a s e
It must be returned
p u t m e
d o w n o n
to the floor to resume
t h e f l o o r .
operation.
The right drop sensor
P l e a s e c l e a n
window on the under
m y r i g h t d r o p
side of Botvac needs
s e n s o r w i n d o w .
to be cleaned.
The left drop sensor
P l e a s e c l e a n
window on the under
m y l e f t d r o p
side of Botvac needs
s e n s o r w i n d o w .
to be cleaned.
™
Neato Botvac User Manual
Make sure the wheel
does not have debris
wrapped around it.
If issue persists,
please contact Neato
Customer Care. Go to
neatorobotics.com
and click on Support
for additional
information.
Place the robot back
on the floor.
Gently clean the drop
sensors with a soft
cloth
Gently clean the drop
sensors with a soft
cloth
44
The bumper or
M y B u m p e r
bumper sensor are
i s s t u c k .
being triggered and
P l e a s e
may be stuck.
f r e e i t .
Botvac needs to
P l e a s e
recharge and cannot
r e t u r n m e
find a charge base.
t o m y b a s e .
45
TM
Gently tap the bumper
to free it — you should
hear TWO clicks when
the bumper is pressed.
One when it is pressed
in and one when it
pops back out.
If the cleaning session
was started from a
charge base:
1. End current
cleaning cycle.
2. Relocate the
charge base to a
more open area
with at least 3 feet
of open space on
either side of it
so the robot can
better locate the
charge base when it
needs to return for
recharging.
3. Take the robot to
the charge base and
restart the cleaning
cycle.
If a cleaning was
started away from a
charge base (example
– for spot cleaning or
to clean another room
without a charge
base) then the robot
will return to where
it started. Pick up the
robot and place it on
the charge base.
™
Neato Botvac User Manual