Yaesu FT DX 3000 Operating Manual page 20

f p
ront anel
[ MIC/SPEED ] Knob
MIC
This knob adjusts the microphone input level for
non processed transmission.
The display will show the relative microphone gain
level for 3 seconds whenever this knob is turned.
A :
dvice
djust the [ MIC/SPEED knob while speaking in a
some hat louder than normal oice le el
le el and adjust the [ MIC/SPEED knob so
that the le el indication just reaches the right
edge of the scale. hen
your normal oice le el you ill not e o er dri ing
the microphone amplifier stages.
SPEED
This knob adjusts the keying speed of the internal
eyer
creases the sending speed.
The display will show the keying speed for 3 sec-
onds whenever this knob is turned.
Page 18
c
ontrols
atch the
hen you spea in
. loc ise rotation in-
& s
witches
[ PROC/CAR ] Knob
PROC
his no adjusts the compression input le el
of the transmitter speech processor in the
mode.
CAR
his no adjusts the
the transcei er. or the
ma imum o er output ia
MAX POWER see page
i n :
MportAnt ote
he setting alue of enu item
is applied to all emission modes.
POWER
For example hen enu item
is set to
POWER 50
output for all emission modes is
[ PROC/CAR
knob is set to the fully clockwise po-
sition.
A :
dvice
he o er output setting
seconds in the right of the TFT display whenever the
[ PROC/CAR
outer no is turned e cept
177 TX MAX POWER
[ PROC
In the SSB mode the
instead of the o er output.
F T 30 00 O
DX
o er arrier output of
mode set the desired
enu item
177 TX
.
177 TX MAX
177 TX MAX
the ma imum o er
e en if the
50
ill e sho n for
hen
is set to atts.
value will be shown
M
peraTing anual