Quadra-Fire VOYA-GRAND-MBK Installation Manual page 24

VOYAGEUR GRAND
Grommet
Route Cord Through
Retainer Clip
9. Insert the power cord through the left side of the appli-
ance in the hole contains the grommet. Pull the connec-
tion ends to the right side. Route the power cord through
the retainer clip.
10. Replace the strain relief on the power cord in the same
position as before. Locate the indentation on the cord
made by the strain relief. Once replaced, push the strain
relief back into the control plate.
Fiber
Wrapped
Wire
11. Connect the white wire on the power cord into the fi ber
wrapped wire on the wire harness. Connect the black
wire on the power cord to the white wire on the rheostat.
Re-attach the green ground terminal to the control plate.
24
Strain Relief
White Wire
Black Wire
Green
Grounding
Wire
Grille hinges
downward
Remove Screws &
Pull Access Assembly
away from Insert
12. Insert the control plate assembly back into the appliance
as shown. Tilt the assembly forward and then lift up and
rotate the bottom towards the front of the appliance at the
same time ensure that the snap disc holder is properly
seated. Secure plate to the appliance.
Route Wires through Retainer Clip
Replace Screws in Hold Down Bracket
13. Push in the blower and hold down bracket into appliance
matching up the tab on the bracket and placement slot
on the appliance. Secure bracket and reconnect blower
wires (no polarity to worry about) routing wires through
the retainer clip.
Blower Access
Assembly
Hold Down
Bracket
7075-209E
Placement Slot
Remove Screws from Hold
Down Bracket and Pull
Forward
August 3, 2015