Lap Belts; Safety Belt Extension Assembly - Lincoln 1997 Town Car Owner's Manual

Lap Belts

The lap belts in the center of the front and rear
seats do not adjust automatically. You must adjust
them to fit snugly and as low as possible around
your hips. Do not wear them around your waist.
Unfastening center lap safety belts
NOTE: Be sure to read and understand Important
Safety Belt Information in this chapter.
134
Pull the belt across your hips and insert the
tongue into the correct buckle on your seat until
you hear a snap and feel it lock. Make sure the
buckle is securely fastened.
If you need to lengthen the belt, unfasten it and tip
the belt tongue at a right angle to the belt. Pull the
belt tongue over your lap until it reaches the
buckle.
If you need to shorten the belt, pull on the loose
end of the webbing until the belt fits snugly.
To unfasten the belt, push the release button on
the buckle. This allows the tongue to unlatch from
the buckle.

Safety Belt Extension Assembly

For some people, the safety belt may be too short
even when it is fully extended. You can add about
eight inches (20 cm) to the belt length with a
safety belt extension assembly (part number
611C22). Safety belt extensions are available at no
cost from your dealer.