Page 2
Nokta Detectors a ms to rema n a lead ng p oneer n ts sector, w nn ng the trust of ts consumers and always be ng the preferred cho ce for metal detect ng.
TAB LE O F CO NTE NTS WARNINGS ................................PARTS and ASSEMBLY ........................CORRECT WAY OF HOLDING and SWEEPING ..........BATTERIES ................................DEVICE INTRODUCTION 8-14 ......................CONTROLS ........................MAIN SCREEN 9-10 ......................NUMERIC DISPLAY ....................MENU 11-14 ..........................SEARCH MODES 15-16 ..........................
WA RNI NGS LEGAL WARNINGS ► When us ng the dev ce, comply w th all appl cable laws and regulat ons. Do not use the dev ce n pr vate prem ses, h stor c s tes and m l tary zones. Not fy the author t es of any h stor cal or cultural f nd ngs.
PAR TS a nd ASSE MB LY Attach the r ght/left armrest components to the S-rod w th the bolts and nuts as seen n the p cture. Do not t ghten the nuts but rather leave them loose (these w ll be t ghtened after the system box s attached).
Page 6
PAR TS a nd ASSE MB LY Wrap the co l cable around the shaft all the way up as shown n the p cture and after nsert ng t n 1)To attach the telescop c shaft to 1)Place the washers nto the the co l nput socket underneath the S-rod, f rst loosen the tw st open ngs at the end of the...
COR REC T WAY O F HO L D I NG Shaft he ght s wrong. Shaft he ght s correct. It s very mportant to adjust the shaft to your Adjust the he ght of the shaft so that you are he ght correctly to be able to search w thout stand ng n an upr ght pos t on, your arm s d scomfort and fat gue.
BAT TERI E S The dev ce comes w th 4 AA Alkal ne batter es. Sl de and remove the battery compartment cover by press ng the latch. Insert the batter es pay ng attent on to the + (plus) and – (m nus) poles. When batter es are full, they w ll prov de approx mately 25-30 hours of use.
D E V I C E I NTRO DU C TI O N CON TRO LS (1) POWER SWITCH: To turn on the dev ce, press the power sw tch to (1) pos t on. The startup tone w ll be heard and after the FORS Gold+ logo s d splayed for a short per od of t me, the ma n screen w ll come up on the LCD panel.
D E V I C E I NTRO DU C TI O N Dur ng Ground Balanc ng: ROCK IRON 1) GROUND BALANCE VALUE Ground 2) GROUND BALANCE FINE TUNE VALUE Balance 3) SEARCH MODE or WARNING MESSAGE Pump The Coil 4) GROUND TRACKING ON/OFF 5) BATTERY LEVEL Dur ng P npo nt ng:...
D E V I C E I NTRO DU C TI O N M ENU The menu screen allows you to access all the FORS Gold+ sett ngs. You can go to the menu screen by press ng one of the up/down/+/- sw tches wh le on the ma n screen and adjust the sett ngs of the dev ce.
Page 13
D E V I C E I NTRO DU C TI O N ID MASKING: ID MASKING When the search co l passes over a target, f the target s gnal s strong enough, a 2-d g t target ID w ll be d splayed on the numer c d splay as well as the LCD panel. Target ID ranges from 0 to 99.
Page 14
D E V I C E I NTRO DU C TI O N NOTE: THE DEVICE WILL START IN TONE 4 IN FST AND BST MODES AND DIFFERENT THAN THE OTHER TONE OPTIONS (TONE 1-TONE 2 -TONE 3 -TONE 5) , IT WILL PROVIDE A SINGLE TONE ONLY.
D E V I C E I NTROD UC TI O N IMPORTANT DETAILS ABOUT MENU USAGE: *If no button s pressed for a few seconds after access ng the menu, the dev ce w ll go back to the ma n screen. If you do not want to wa t, you can press and release the p npo nt button once to go to the ma n screen as well.
S EA RC H M OD E S GENERAL SEARCH MODE (GEN): Somet mes referred to as the ''All Metal'' mode, th s s the deepest mode of the dev ce and the dev ce w ll start up n th s mode. D erent than the other modes, th s mode has a constant threshold sound n the background.
Page 17
S EA RC H M OD E S NOTE: THE DEVICE WILL START IN TONE 4 IN FST AND BST MODES AND DIFFERENT THAN THE OTHER TONE OPTIONS (TONE 1-TONE 2 -TONE 3 -TONE 5) , IT WILL PROVIDE A SINGLE TONE ONLY. IN OTHER WORDS, THE DEVICE WILL PROVIDE 2 DIFFERENT TONES FOR IRON AND GOLD/NON-FERROUS METALS IN THE OTHER TONE OPTIONS BUT IN TONE 4 IT WILL PROVIDE THE SAME TONE FOR ALL METALS (GOLD, NON-FERROUS, FERROUS).
G RO U ND BA L A NCE One of the follow ng may happen as a result of mproper ground balanc ng: -The dev ce g ves a s gnal when the co l s swept over the ground where there s no target. -The dev ce s s lent but loses detect on depth for certa n metals.
Page 19
G RO U ND BA L A NCE After the ground balance button s released, the dev ce w ll work n the General Search mode and the ground balance value w ll rema n on screen for a wh le. (If you do not want to wa t for th s per od you can go to the ma n screen by press ng and releas ng the p npo nt button once).
Page 20
G RO U ND BA L A NCE 4. Cont nue the above process unt l the sound s el m nated. If the sound s not completely el m nated, then you can f ne tune. For f ne tun ng, follow the numbers above the symbol and use the + and - sw tches.
Page 21
G RO U ND BA L A NCE GROUND BALANCE VALUE: The ground balance value nd cates the type of ground. Some typ cal ground types are as follows: 0-25 Wet salt water or wet alkal so ls 25-50 Wet salt water and wet alkal so ls covered w th dry layers 50-70 Regular, low-qual ty so ls 70-90...
S ENS IT I V I T Y, i S AT and TH RE SH O L D Adjust ng these three sett ngs correctly s cr t cal for the dev ce to work at ts best performance and w thout no se. It s poss ble to obta n an average performance w th the startup sett ngs.
S ENS IT I V I T Y, i S AT and TH RE SH O L D To adjust the sens t v ty sett ng n d scr m nat on modes, ground balance f rst w th the sens t v ty set at ts default value.
TA RG E T I D and I D MA SKI NG ROCK IRON Brown Area (Target ID: 0-16): H ghly m neral zed so l and pos t ve or negat ve hot rocks. Blue Area (Target ID: 16-40): Ferrous metals (Gold under rocks can also fall nto th s category.
PI NPO I NT P npo nt ng s to determ ne the center or the exact locat on of a detected target. FORS Gold+ operates on the pr nc ple of mot on. Th s means that you must move the search co l over the target or the target over the search co l, n order for the dev ce to detect t.
D EP TH I ND I C ATI O N The dev ce g ves an est mated depth read ng based on s gnal strength n the p npo nt mode. When the p npo nt button s pressed and the target s approached, the depth read ng w ll appear n ''cm.'' on the LCD panel and the numer c d splay s multaneously.
MAG NE T I C M I NE R AL I Z ATIO N L E V EL Magnet c M neral zat on level ranges from 0-99 and s d splayed n the Magnet c M neral zat on Ind cator on the Target Target r ght s de of the ma n screen.
HOT ROC K S and S EA RCH I NG I N RO CKY AREA S At h gher sett ngs of SAT, there w ll be no change n the sounds of pos t ve or negat ve hot rocks.
Page 29
M E TA L S U N D ER H OT RO C KS The other reason s a geolog cal one and s a commonly encountered s tuat on n gold prospect ng f elds. There has been a correlat on between the format on of hot rocks and the format on of gold underneath or around them w th n the m ll ons of years geolog cal process.
M E SSAGE S At the bottom of the LCD panel, on the ma n screen, messages w ll appear f any. If there s no message, the present search mode name w ll be d splayed. Messages that may appear are as follows: OVERLOAD: It appears s multaneously w th the overload warn ng alarm sound ng l ke a s ren.
FAC TORY and S TA R T UP S E T TI N GS The techn cal sett ngs of the dev ce (Mode, Ground Balance, Sens t v ty, SAT, Threshold, and ID Mask ng, Frequency) come w th the r factory default values at each startup. Personal sett ngs (Volume, Tone, V brat on, Br ghtness, and Language) come w th the last adjusted value when the dev ce s turned o and on aga n.
Warranty 2 years Nokta Detectors reserves the r ght to change the des gn, spec f cat ons or accessor es w thout not ce and w thout any obl gat on or l ab l ty whatsoever. Page 31...
Need help?
Do you have a question about the FORS Gold+ and is the answer not in the manual?
Questions and answers