Martin MAC Quantum Profile Safety And Installation Manual page 15

Removing the multi-module
You need to remove the multi-module from the head if you want to replace the static gobo wheel or if you
want easier access to the rotating gobo wheel.
To remove the multi-module:
1. Open the head as described above.
2. See Figure 10. Disconnect the two plugs (arrowed) on the right-hand side of the head, then push the two
multi-module latches in towards the centre of the multi-module.
3. See Figure 11. Lift the multi-module out
of the head and place it on a clean work
surface.
To reinstall the multi-module, follow the
above steps in the reverse order.
Handling and storing gobos
The MAC Quantum Profile uses specially-designed borosilicate
gobos with a heavy matted aluminum coating that require
particularly careful handling and storage.
The use of metal gobos in the MAC Quantum Profile is not
recommended.
Do not use gobos with dark coatings on any side, as these will
absorb heat – either directly from the lamp or reflected back from
other optical components – and will not be durable.
1. Store all gobos in a dust-free environment with approx. 50%
humidity.
2. Always use clean gloves when handling gobos.
3. Avoid touching the other gobos when taking out a gobo from the
rack: the sharp edge of one gobo can scratch the others.
4. Clean the coated side of gobos with dust and oil-free
compressed air only.
Figure 10: Releasing the multi-module
Service and maintenance
Figure 11: Removing the multi-module
Figure 12: Rotating gobo holder
15