Miele WT 945 S WPS Operating Instructions Manual page 49

Problem
The laundry is still
damp after a drying
cycle.
There is still water in
the drum after drying.
Possible cause
The load weighed less
than 1 kg. The moisture
sensing system cannot
operate with too small a
load.
When washing and
drying in one continuous
sequence:
during the spin the laundry
formed a ring in the drum
because the laundry was
distributed unevenly.
When drying separately:
during the Thermospin the
laundry formed a ring in
the drum because the
laundry was too damp or
because the spin was set
too high.
There is a blockage in the
water outlet.
Problem solving guide
Remedy
In future dry small loads in
a TIMED DRYING
programme.
– Turn the WASHING and
DRYING programme
selectors to the Finish
position.
– Open the door and
loosen the laundry.
– Select a lower spin
speed.
– Start the drying
programme again.
Clean the fluff filter and the
drain pump as described in
"Opening the drum door in
the event of a blocked
drain outlet and/or power
failure".
49