TP-Link Arher C3200 User Manual page 7

Name
(2.4GHz)
(5GHz-1)
(5GHz-2)
(Ethernet)
(Internet)
(WPS)
(USB 1/USB 2)
Note:
After a device is successfully added to the network by WPS function, the WPS LED will keep on for about 5 minutes and then turn off.
The following buttons are also located on the front panel (View from left to right). Refer to the following for detailed instructions.
Button
(Wi-Fi)
(WPS)
(LED On/Off)
Chapter 1 Get to Know About Your Router
Status
On 2.4GHz wireless is working properly.
Off 2.4GHz wireless is disabled.
On 5GHz-1 wireless is working properly.
Off 5GHz-1 wireless is disabled.
On 5GHz-2 wireless is working properly.
Off 5GHz-2 wireless is disabled.
On There is device(s) connected to the Ethernet (1/2/3/4) port(s).
Off No any device is connected to the Ethernet (1/2/3/4) port.
Blue The Internet port is connected, and the Internet is accessible.
Orange The Internet port is connected, but the Internet is inaccessible.
Off The Internet port isn't connected, and the Internet is inaccessible.
WPS button on the router is pressed, and the router is trying to connect a wireless device
Flash
to its network via WPS.
On The connection via WPS is successful.
Off The connection via WPS fails.
Flash The router is identifying the device connected to the USB 2.0 port/USB 3.0 port.
On The device is identified successfully.
Off No device is connected to the USB 2.0 port/USB 3.0 port.
Pressing this button for 2 seconds enables or disables the Wi-Fi function.
Pressing this button for less than 5 seconds enables the WPS function. If your client devices, such as wireless
adapters, support Wi-Fi Protected Setup, then you can press this button to quickly establish a connection
between the router and client devices and automatically configure wireless security for your wireless network.
Pressing this button for 1 second turns all LEDs on or off.
Indication
Description
4