TP-Link Arher C3200 User Manual page 58

Done!
Note:
1. The product supports a maximum of ten simultaneous connections.
2. If one of the site has been off line for a while, for example, if Site A has been disconnected, on Site B you need to click
click Enable after Site A back on line in order to re-establish the IPSec tunnel.
Chapter 11 Customize Your Network Settings
9 ) Leave the Advanced
3. Configuration on Site B (remote network). Refer to step 2 configuration on Site A and make sure
that Site A and Site B use the same
4. The Status column will change to
5. Check the VPN connection. You can ping site B' LAN IP from your computer in site A to verify that
the IPSec VPN connection is set up correctly.
Tips: To check the VPN connection, you can do the following.
a . On the host in Site A, press
b . In the CLI window, type in "ping 192.168.2.x" ("192.168.2.x" can be IP address of any host in
Site B). Then press [Enter].
If Ping proceeds successfully (gets replies from host in Site B), the IPSec connection is working
properly now.
Now IPSec VPN is implemented to establish a connection.
Settings as default value. Then click
Pre-shared keys
UP if the VPN connection has been set up successfully.
[Windows Logo] + [R]
OK to save.
and Perfect Forward Secrecy
to open Run dialog. Input "cmd" and hit
settings.
OK.
Disable and then
55