Specify Dhcp Server Settings - TP-Link Arher C3200 User Manual

I want to:
How can I
do that?
Done!
11. 3.

Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the router acts as a DHCP server; it
dynamically assigns TCP/IP parameters to client devices from the IP Address Pool. You can change the settings of DHCP Server
if necessary, and you can reserve LAN IP address for specified client device.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router.
2. Go to Advanced > Network
Chapter 11 Customize Your Network Settings
Configure the router to enable Internet Protocol Television (IPTV) Services.
For example, I already bought IPTV service, but this service can only be delivered through the
Internet. Therefore, I need to configure my router first.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router.
2. Go to Advanced > Network
3. Configure IPTV settings:
1 ) Select the Enable IPTV
2 ) Select the appropriate
no other parameters are required, and then skip to substep 4. Select
listed but provides necessary parameters.
3 ) After you have selected a mode, the necessary parameters are predetermined. You can
perform other configuration, e.g. enter the
Multicast VLAN Priority
elect the IGMP Proxy
4 ) S
ISP.
5 ) For Russia, Singapore-ExStream, Malaysia-Unifi and Malaysia-Maxis mode, connect device to the
predetermined LAN port. For Bridge and Custom mode, select a LAN port as the IPTV port and connect
the set-top box to the corresponding port.
Save
6 ) Click .
Your IPTV setup is done now! You may need other configurations on your set-top box before
enjoying your TV.
> DHCP Server.
> IPTV to open the configuration page.
check box.
Mode according to your ISP. Select
IPTV Multicast VLAN ID
in Russia mode according to your ISP.
version, either V2 or V3, according to the information provided by your
Bridge if your ISP is not listed and
Custom if your ISP is not
and select the IPTV
44