Bayer HealthCare CONTOUR NEXT LINK User Manual page 15

Wireless blood glucose monitoring system
Hide thumbs Also See for CONTOUR NEXT LINK:
Table of Contents

Advertisement

STRIP UNDERFILLED
APPLY MORE BLOOD NOW
Too Little Blood
Remove used strip.
Repeat test with new
strip.
E01
AUTOLOG
Fasting
OK
Before Meal
After Meal
No Mark
NOTE:
• Your test result does not display until you make an
AutoLog selection.
• If your result is above or below your High or Low
Alert settings, you will see your result without pushing
a button.
YOUR RESULTS
9.3
mmol
Send
L
Don't Send
Before Meal
Options, you will not have the option to send the result to your
pump. If Ask Me was selected in Send Options, you can choose
to send your result to your pump after each blood sugar test.
Press Send or Don't Send. If Send is chosen, press OK on the
Send confirmation screen. You can change your send option at
any time using the Setup Menu (see page 42).
22
22
If the first blood drop is
not enough, the meter will
beep twice and display
" STRIP UNDERFILLED" and
"APPLY MORE BLOOD NOW."
You have about 30 seconds
to apply more blood to the
same strip.
If you do not apply more
blood within about 30
seconds, remove the strip
and repeat with a new strip.
9. If you have the AutoLog
feature turned ON, the
AutoLog screen appears.
Fasting,
Before
Select
Meal,
After Meal, or No
Mark by pressing the OK
button when your selection
is highlighted. Scroll down to
see No Mark.
If Always was selected in
Send Options during Setup,
your result is automatically
sent to your pump. If Never
was selected in Send
WARNING
• Do not calculate a bolus based on an AST result.
• Do not calibrate your continuous glucose monitoring
device from an AST.
If you are done, remove the test strip from the meter. Press and
hold the top Menu button to turn off the meter. The meter also
turns off after 3 minutes of inactivity.
Removing the Used Lancet
1. In one hand, hold the lancing
device with your thumb on the
grip indent, with your other hand,
hold the endcap as shown, and
gently snap off the endcap.
2. Place the round protective lancet
cap on a flat surface with the
Bayer logo facing down.
3. With the used lancet still in the
lancing device, push the lancet
needle completely into the
middle of the exposed side of
the cap.
b
a
4. While pressing the release
button (a), pull the re-setting
handle (b), and the lancet will
drop into the container you
have selected.
WARNING
• Dispose of the used lancet as medical waste or as
advised by your health care professional.
Do not reuse lancets. Use a new M
each time you test.
®
lancet
ICROLET
23

Advertisement

Table of Contents
loading

Table of Contents