Philips YS534 User Manual page 13

- Clean the appliance and the attachments after every use to prevent pollution
of the shaver and blockages.
- You can clean the outside of the appliance with a damp cloth. Do not clean an
attachment with a cloth.
Cleaning the shaving attachment
- Clean the shaving heads frequently with Philips Shaving Head Cleaning Spray
(HQ110) for optimal shaving performance.
1 Switch off the appliance.
2 Press the release buttons on the shaving attachment (1) and pull the shaving
unit off the shaving attachment (2) (Fig. 22).
3 To unlock the orange retaining ring, turn it in the direction of the arrows
indicated in and on the retaining ring (Fig. 23).
4 Lift the retaining ring out of the shaving head holder. (Fig. 24)
5 Remove one cutter and its shaving guard (Fig. 25).
Do not clean more than one cutter and shaving guard at a time, since they are all
matching sets. If you accidentally put a cutter in the wrong shaving guard, it may take
several weeks before optimal shaving performance is restored.
6 Clean the cutter with the cleaning brush supplied (Fig. 26).
7 Clean the inside of the shaving guard (Fig. 27).
You can also clean the cutter and its guard under a tap of hot water.
8 After cleaning, place the shaving guard back into the shaving head holder.
Make sure the two wings fit exactly into the recesses of the shaving head
holder (Fig. 28).
9 Place the cutter back into the shaving guard with the cutter legs pointing
downwards.
10 Place the retaining ring back onto the shaving head holder (1).
To reattach the retaining ring, turn it against the direction of the arrows
indicated in and on the retaining ring (2) (Fig. 29).
Make sure the retaining ring is fixed properly. The four wings of the retaining ring have
to be located exactly under the recesses of the shaving head holder.
Repeat step 1-10 for the other shaving heads.
EngliSh
13