Removing The Thermostat Base
To remove the thermostat base:
•
Locate the tab on the bottom of the
thermostat.
•
Push the tab with either your thumb or
with a screwdriver.
•
Lift the thermostat front away from the
thermostat's base.
Mounting The Thermostat Base
If a single gang box is used:
•
Feed the wiring through the large
hole of the thermostat base.
•
Fasten the base of the thermostat
to the gang box.
•
Terminate wiring to the wiring
strip.
•
Push the thermostat front onto
the thermostat base.
If a gang box is not used:
•
Feed the wiring through the large
hole in the thermostat base.
•
Mount the thermostat base
directly to the wall.
•
Use screws in the screw holes
to fasten the thermostat to the
wall. At least one of the screws
should enter a wall stud or
similar rigid material.
•
Terminate wiring to the wiring
strip.
•
Push the thermostat front onto
the thermostat base.
A Watts Water Technologies Company
Thermostat
Thermostat
Front
Thermostat
Thermostat
Base
Front
5 of 44
Base
1
3
/
"
4
(83 mm)
© 2014
552_D - 09/14
Stud
Gang
Box
Stud
Wall