Attaching The Stand Unit - Sharp LC-32D65E Service Manual

LC-32D65E/RU, LC-37D65E/RU

Attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent
it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1
Confirm that there are eight screws with the
stand unit.
2
Attach the supporting post for the stand unit
onto the base using the four screws with the
screw driver (supplied) as shown.
3
Inserting the stand.
Insert the stand into the openings on the
bottom of the TV (Hold the stand so it will
not drop from the edge of the base area).
Insert and tighten the four screws into the
four holes on the rear of the TV.
Supporting
post
NOTE
• To detach the stand unit, perform the steps in reverse
order.
1 – 4
Soft cushion