Public Mode - Sharp LC-32D65E Service Manual

8. Public Mode (Hotel Mode)
1. Starting the Public Mode
• There are two following ways to display the PUBLIC Mode setting screen.
1) On the process adjustment mode screen (2/16), set the "HOTEL MODE" Flag to ON.
Turn off the power, and turn it on again, pressing the
2) Enter the Pass Word, and start the unit.
a) Turn on the power, pressing the
b) Display the Pass Word input screen.

Public Mode

Operation procedure
• The initial input position is the digit at the left end.
• For the numeric keys
• Change "–" to "*" by inputting the numeric key at the input position, and shift the input position rightward one digit.
• When three digits are completely input, the Pass Word is judged.
c) Check the Pass Word by inputting three digits.
If the Pass Word is
0
In another case, the screen is erased, and it operates in the ordinary mode.
2. Exiting the Public Mode screen
• There are two following ways to exit the Public Mode setting screen.
1) Turn off the power.
2) Select "Execution" in the PUBLIC_Mode to execute it.
Activate the restart under the set content. Here, the START input SOURCE setting is excluded since this item is referred to only when the
power is turned on.
3. Set value of the Public Mode
• When the shipment setting is done, a set each value in Public Mode is initialized.
(PUBLIC MODE in the process mode Setting of a flag is also initialized)
• Separately, the shipment beginnings when all except for each set value in Public Mode is initialized are provided for a process mode. (INDUS-
TRY INIT (-HOTEL) )
• Only when turning on the HOTELE MODE item, each setting is effective.
• After it decides it with EXECUTE, it AC OFF/ON it to reflect a set value.
CHANNEL UP
INPUT
and
Volume UP
to of R/C, key input is accepted. Input of the other keys is prohibited.
0 9
, it shifts to the PUBLIC Mode setting screen.
2 7
and keys of the main unit at the same time.
Volume UP
keys of the main unit at the same time.
Public Mode
3 – 6
LC-32D65E/RU, LC-37D65E/RU
Public Mode