Related Manuals for Helipal Storm Drone 8
Summary of Contents for Helipal Storm Drone 8
- Page 1 Storm Drone 8 with Naza V2 GPS Flight Controller USER MANUAL V2.0 Copyright@2015 HeliPal.com. All Rights Reserved...
- Page 2 6) Never overcharge LiPo batteries. Do not charge above 4.2V per cell. When the battery is fully charged, disconnect it from the charger. Never leave the battery charger unattended during charging. 7) Never discharge batteries to below 3.3V per cell 8) Remove batteries when not using the drone. Copyright@2015 HeliPal.com. All Rights Reserved...
- Page 3 Package includes: 1. Fully Assembled Storm Drone 8 GPS Flying Platform 2. RadioLink 2.4Ghz AT9 Radio System w/ R9D 9-Ch Receiver 3. 11.1V 5500mah 30C Li-Po Battery 4. 8pcs Clockwise Blade Propeller (4 of them are spare parts) 5. 8pcs Counter-Clockwise Blade Propeller (4 of them are spare parts) 6.
-
Page 4: Quick Start
Quick Start Copyright@2015 HeliPal.com. All Rights Reserved... - Page 5 Copyright@2015 HeliPal.com. All Rights Reserved...
- Page 6 Control Copyright@2015 HeliPal.com. All Rights Reserved...
- Page 7 If the transmitter is off, push throttle stick to down position, turn on the transmitter, push throttle to middle, switch the G switch Down(towards you) and Up(away from you) to take over the control again. Copyright@2015 HeliPal.com. All Rights Reserved...
- Page 8 2. NAZA V2 Manual It is important to learn more about the NAZA-M V2 GPS Controller. You can download the manual here: http://download.dji-innovations.com/downloads/nazam-v2/en/NAZA-M- V2_Quick_Start_Guide_en.pdf Copyright@2015 HeliPal.com. All Rights Reserved...
-
Page 9: Circuit Diagram
Circuit Diagram Copyright@2015 HeliPal.com. All Rights Reserved... -
Page 10: Fpv System
100110 5847MHz 100010 5752MHz 011010 5860MHz 100000 5760MHz 011000 5865MHz 111110 5765MHz 010110 5866MHz 000010 5771MHz 101010 5880MHz 000000 5780MHz 101000 5885MHz 110100 5785MHz 110110 5905MHz 010100 5790MHz 001010 5925MHz 100100 5800MHz 001000 5945MHz 000100 Copyright@2015 HeliPal.com. All Rights Reserved... - Page 11 Use the small screwdrivers to press and hold the switch inside the receiver until it is flashing with light in Blue and Purple, Switch on the radio controller, it will start searching for available receiver. Receiver will stop flashing while the bind process complete and the radio controller will the signal strength on the screen Copyright@2015 HeliPal.com. All Rights Reserved...
- Page 12 Go to [AUX-CH] -> ATTITUDE, apply the setting below: [CH8] = VrB [CH9] = SwA [CH10] = SwB [CH] = CH7 [SW3] = SwG [SW2] = NULL [GPS] = 0% [ATTI.] = 50% [ATTI.] = 100% Copyright@2015 HeliPal.com. All Rights Reserved...
- Page 13 As less vibration would offer better video quality and control stability, a propeller balancer is included for you to balance the propeller if necessary. Copyright@2015 HeliPal.com. All Rights Reserved...