Repeater Or Direct Operation; Monitoring Features - Motorola EMS APX 7500 User Manual

Repeater or Direct Operation

The REPEATER operation increases the radio's range by
connecting with other radios through a repeater. The transmit
and receive frequencies are different.
The DIRECT or "talkaround operation" allows you to bypass the
repeater and connect directly to another radio. The transmit and
receive frequencies are the same.
Procedure:
Press the preprogrammed Repeater/Direct switch to toggle
between talkaround and repeater modes.
OR
Follow the procedure below.
> <
1
or to DIR.
2
Press the Menu Select button directly below DIR.
3
The display shows REPEATER MODE if the radio is currently
in Repeater mode.
OR
The display shows DIRECT MODE and the Talkaround icon if
the radio is currently in Direct mode (during conventional
operation only).
You can repeat step 2 to toggle between the two modes. Once
in Direct Mode, press PTT button to start conversation with the
radios nearby.

Monitoring Features

Radio users who switch from analog to digital radios often assume that
the lack of static on a digital channel is an indication that the radio is
not working properly. This is not the case.
Digital technology quiets the transmission by removing the
"noise" from the signal and allowing only the clear voice or data
information to be heard.
Monitor a channel to ensure the channel is clear before transmitting.

Monitoring a Channel
Procedure:
Lift the microphone off hook.
Conventional Modes Only:
1 Listen for activity on that channel.
2 Adjust the Volume knob if necessary.
3 If you hear no activity, press and hold the PTT button to start
your conversation.
OR
Trunked Modes Only:
Press the PTT button.
2
If you hear two, short, high-pitched tones, or if you hear no tone
and the t indicator lights steadily, then proceed with your message.
3 Release the PTT button to receive (listen).
If you are not in the range of the system, you may hear a continuous
low-pitched tone and the display shows
11/2/15
1
OUT OF RANGE
.
20
English