Toyota 2015 Prius C Owner's Manual page 427

License plate light
■
1
Remove the cover.
Insert a properly sized screw-
driver into the hole of the cover,
and pry off the cover as shown
in the illustration.
To prevent damaging the vehi-
cle, wrap the tip of the screw-
driver with tape.
2
Remove the light bulb.
3
When installing, reverse the steps listed.
Lights other than the above
■
If any of the lights listed below has burnt out, have it replaced by
your Toyota dealer.
● Headlight low/high beam/daytime running lights
● Front fog lights (if equipped)
● Side turn signal lights
● Stop/tail lights
● High mounted stoplight
LED light bulbs
■
The headlight low/high beam/daytime running lights, front fog lights (if
equipped), stop/tail lights and high mounted stoplight consist of a number of
LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to
have the light replaced.
Condensation build-up on the inside of the lens
■
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction. Contact your Toyota dealer for more information in the
following situations:
●
Large drops of water have built up on the inside of the lens.
●
Water has built up inside the headlight.
7-3. Do-it-yourself maintenance
I n f o r ma t i o n P r o v i d e d b y :
427
7