Toyota 2015 Prius C Owner's Manual page 142

142
3-2. Opening, closing and locking the doors
Notes for locking the doors
■
●
Touching the door lock sensor while wearing gloves may delay or prevent
lock operation. Remove the gloves and touch the lock sensor again.
●
When the lock operation is performed using the lock sensor, recognition sig-
nals will be shown up to two consecutive times. After this, no recognition
signals will be given.
●
If the electronic key is inside the vehicle and a door handle becomes wet
during a car wash, a buzzer will sound outside the vehicle. To turn off the
alarm, lock all the doors.
Notes for the unlocking function
■
●
A sudden approach to the effective range or door handle may prevent the
doors from being unlocked. In this case, return the door handle to the origi-
nal position and check that the doors unlock before pulling the door handle
again.
●
Gripping the door handle when wearing a glove may not unlock the door.
Remove the gloves and touch the sensor on the back of the handle again.
●
If there is another electronic key in the detection area, it may take slightly
longer to unlock the doors after the door handle is gripped.
When the vehicle is not driven for extended periods
■
●
To prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2
m) of the vehicle.
●
The smart key system can be deactivated in advance. Ask your Toyota
dealer for details.
To operate the smart key system properly
■
Make sure to carry the electronic key when operating the system. Do not get
the electronic key too close to the vehicle when operating the system from the
outside of the vehicle.
Depending on the position and holding condition of the electronic key, the key
may not be detected correctly and the system may not operate properly. (The
alarm may go off accidentally, or the door lock prevention function may not
operate.)
If the smart key system does not operate properly
■
●
Locking and unlocking the doors: Use the mechanical key. (P. 476)
●
Starting the hybrid system:P. 476
If the smart key system has been deactivated in a customized setting
■
●
Locking and unlocking the doors: Use the wireless remote control or
mechanical key. (P. 125, 476)
●
Starting the hybrid system and changing "POWER" switch modes:
P. 476
Stopping the hybrid system: P. 477
●
Customization that can be configured at Toyota dealer
■
Settings (e. g. operation signals) can be changed.
(Customizable features: P. 514)
I n f o r ma t i o n P r o v i d e d b y :