Mx-Trx2 (Exit Tray Unit) - Sharp MX-4110N Installation Manual

MX-5111N

[7] MX-TRX2 (EXIT TRAY UNIT)

1. Unpacking
A. Removal of the exit tray unit
B. Packed items check
1
No. Name
1 Exit roller unit
2 Full detection actuator
2. Installation
NOTE: Before installation, be sure to turn both the operation and
main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.
A. Installation of the exit roller unit
1) Open the right door. Remove the screw, and remove the con-
nector cover.
Service Manual
2)
3)
2
Quantity
4)
1
1
MX-5111N MX-TRX2 (EXIT TRAY UNIT) 7 – 1
Remove the screw. Disengage the engagement in the front
side then in the rear side, and remove the paper exit cover.
4
3
Connect the connector, and install the exit roller unit (Packed
items). Use the screw which was removed in step 3) and fix
the unit.
Install the connector cover, and fix it with the screw.
1
2