Charging The Batteries; Battery Safety - Datalogic Gryphon I GBT4400 Quick Reference Manual

Charging the Batteries

Charging the Batteries
To charge the battery, simply insert the Gryphon into the base.
When the scanner is fully seated in the cradle, it will sound a
"chirp" to indicate that the cradle has detected the scanner
connection.
The LEDs on the base (shown in
tus of the battery.

Battery Safety

To install, charge and/or perform any other action on the bat-
tery, follow the instructions in this manual.
WARNING
WARNING
10
Before using the Battery, read "Battery Safety" in the follow-
ing section. Datalogic recommends annual replacement of
rechargeable battery packs to ensure maximum perfor-
mance.
Do not discharge the battery using any device except for
the scanner. When the battery is used in devices other
than the designated product, it may damage the battery
or reduce its life expectancy. If the device causes an
abnormal current to flow, it may cause the battery to
become hot, explode or ignite and cause serious injury.
Lithium-ion battery packs may get hot, explode or ignite
and cause serious injury if exposed to abusive conditions.
Be sure to follow the safety warnings listed on the follow-
ing page.
• Do not place the battery pack in fire or heat.
• Do not connect the positive terminal and negative
terminal of the battery pack to each other with any
metal object (such as wire).
• Do not carry or store the battery pack together with
metal objects.
• Do not pierce the battery pack with nails, strike it
with a hammer, step on it or otherwise subject it to
strong impacts or shocks.
• Do not solder directly onto the battery pack.
• Do not expose the battery pack to liquids, or allow
the battery to get wet.
• Do not apply voltages to the battery pack contacts.
) will indicate the sta-
Table 1
Gryphon™ I GBT4400