Drying Heating Element - Electrolux HEC-RIM SEries Service Manual

Turn the fan unit clockwise as shown in the figure.
Position the fan between the condenser and the heating
element casing.
Lift and remove the fan unit.

6.3 Drying heating element

Remove the screw which secures the plastic duct to the
heating element casing. (b)
Remove the two screws which secure the heating element
casing to the cross-member. (c)
Remove the screw which secures the fan to the heating
element casing. (d)
Remove the screws which secure the fan to the cabinet (e) and
to the cross-member. (f)
Detach the heating element casing from the fan unit as
described in the previous paragraph.
Detach the connectors (note their positions carefully).
Remove the two screws which secure the heating element to
the casing and remove the heating element.
When re-assembling, ensure that the heating element and the
gasket are positioned as follows:
-the heating element must be positioned perfectly inside the
casing
-the gasket must be positioned so that no heat loss occurs.
SOI/DT 2007-11 dmm
10/14
d
c
c
b
e
f
599 70 40-15
c