Elevator Controls - RC Guys Super Decathlon ARF Assembly Manual

Elevator Controls
Collect these parts.
ÿ 2 ­ elevator servos and mounting hardware
ÿ 2 ­ 18 inch elevator extension leads
ÿ 2 ­ threaded elevator control rods
ÿ 2 ­ servo clevises
ÿ 2 ­ control horn trumpet bases
ÿ 2 ­ trumpet clevises. (black plastic)
ÿ 2 ­ trumpet washers
ÿ 2 ­ trumpet screws
Possition the trumpet base at the edge of the elevator beveled edge 1­1/4" from the rudder. Mark the spot and drill a 3/32"
dia. hole through the elevator. Install the trumpets using the supplied hardware. Do not over tighten the screws.
Note: Strengthen the holes by applying a few drops of CA glue in each hole to reduce the amount of balsa
compression.
Install the elevator connecting rods to the servo arms and trumpets.
Note: Make sure the servo arms exit on opposite sides to ensure
the elevators will travel in the same direction. If you are
connecting the same receiver channel you will need a Y servo
extension and one 18 inch extension.
Using the hardware supplied from your radio, install the elevator
servos on both sides of the fuse.
You will need to connect 2 x 18 inch servo leads if you are
connecting the 2 servos to different receiver channels.
­7­