Line up the wheel pant with the graphics on the fuse so that they are parallel and even.
Mark or scribe through the holes in the landing gear legs onto the wheel pants.
Center the wheel in the pants and tighten the lock collars. Make sure
the wheel turns freely.
Drill 2 x 1/8 dia. holes on these marks.
Install the T nuts from inside the wheel pants.
Using the supplied hardware, 2 x 632 bolts and washers, secure the wheel
pants to the gear legs. Make sure these are very tight.
Note: Be very careful that you do not cross thread any of the bolts as this
may loosen the T nuts.
10