Table of Contents
Advertisement
Cowl Installation
Collect these parts.
ÿ 1 engine cowl
ÿ 5 hardwood blocks
ÿ 5 wood screws
Locate and epoxy the 5 hardwood cowl blocks to the fuse firewall as
shown. You may want to roughen the firewall to ensure a better bond for
the epoxy.
Using a black marker, put a dot in the center of the wood blocks.
Make up some hole locators using card stock or heavy paper. Punch a 1/8
inch hole in one end and center this hole over the black dot on the wood
blocks.
Tape the other end of the card to the fuse.
Test fit the cowl so the distance from the front edge of the cowl to the
firewall is 6¼ inches leaving 1/16 to 1/8 inches clearance of the
propeller.
Slide the cowl over the engine and align the side graphics so that they are
straight and even.
22
Advertisement
Table of Contents
