Operating Elements; Preparing For Start-Up; Unpacking The Appliance En; Installing The Access Ramp Of The Station - Kärcher RC 4.000 Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19

Operating elements

Illustrations on fold-out
pages!
Station for cleaning robot
1 Transport handle, retractable
2 Recessed grip to open the filter cover
3 Operating panel of the station
4 ON/OFF switch of the station
5 IR sender
6 Suction hole
7 Access ramp for the cleaning robot (to
dock onto the station)
8 Battery contacts
9 Power cord
Operating panel of station (3)
A Indicator lamp (green) - parking the
cleaning robot
B "Parking the cleaning robot" button –
ON/OFF
C "Select cleaning duration" button
D Indicator lamp (green) – 3 hours of
cleaning
E Indicator lamp (green) – 6 hours of
cleaning
F Indicator lamp (green) – 9 hours of
cleaning
G Indicator lamp (green) - continuous
cleaning
H Indicator lamp (red) - filter full
I
Button "quiet mode" – ON/OFF
J
Indicator lamp (green) – quiet mode
Cleaning robot
10 Button "Switch on cleaning robot"
11 Button "Switch off cleaning robot"
12 LEDs
(Green - operation / red - failure)
13 Battery contacts
14 IR receiver
15 Safety bumper
16 Brush roller
17 Optical sensors (4x)
18 Battery packs (2x)
19 Locking lever dirt receptacle (2x)
22
20 Cover of the dirt receptacle
21 Dirt receptacle

Preparing for start-up

Unpacking the Appliance
The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for disposal, but
arrange for the proper recycling.
Illustration
 When you unpack the system, check
that everything is complete.
If there are any missing parts or you de-
tect any transport damage when un-
packing, please inform your dealer
immediately.
Installing the access ramp of the
Illustration
 Hold the access ramp tilted. Insert the
cut-outs of the station into the pins of
the access ramp.
 Press the station and the access ramp
downwards until the connection locks
into place.

Installation Notes for the Station

When you select the location of the station,
please make sure that the cleaning robot is
very likely to pass the infrared beam again
and again to easily find its way back to the
station.
Illustration
 Secure the power cord in the cable
hooks. Please make sure that the pow-
er cord is guided through the opening in
the housing.
Note: Uncoil the power cord only to the
required length.
 Place the station on a level surface.
– 4
EN
station

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents