Installation; Placement Of The Washing Machine; Installation Of Water Inlet Hose; Installation Of Drain Hose - Philco GJW60P User Manual

INSTALLATION

Placement of the washing machine

The washing machine should be placed inside the room with a flat floor, where is convenient for water
supply and drainage, has low moisture and no direct sunshine, and does not freeze in winter. All foam packing
(including the fixing frame on the base foam) should be taken off.
Levelling the washing machine according to the instructions below to make the washing machine run
steadily in low noise.
1. Loose the fixing pole on the adjusting foot, screw in or screw out the adjustable foot to make the four
braces placed even on the floor. (the adjustable foot is on the left front bottom of the cabinet).
2. When the floor is slanting or uneven, the rubber band can be added to the unflat place.
3. Use a thread tied with bulky object, hang it on the side face and face side, or see the hole of the top
frame and the washing tub are found to be basically in alignment, that is to show that the washing
machine is placed flat, just like followed figure.
4. After the adjustment the fixing pole should be screwed back and tight.
Notices:
If the washing machine is not placed flat (the inclination angle is over 2 ), it may cause great vibration or
automatic check and rectification or other abnormal circumstances will often take place in the course of
spinning .
Loose
Fixing pole
Tight
Installation of the water inlet hose
1. Check the tap mouth. If it is not even, it can be filed even.
2. Screw loose the locking ring, but do not let the locking ring drop off. Screw the four screws at the same
distance.
3. Put the universal connector into the tap and stick to the tap mouth at the most and then screw in the screws.
4. Screw tight the locking ring to the right at the most.
5. Pull the skirt of one end of the water inlet hose downwards, and then plug in the universal connector. A
sound of "KA-TA" means proper connection.
This Manual: http://www.manuallib.com/file/2533054
o
Base foam Fixing frame
Adjustable foot
Screw in
Screw out
3
INSTALLATION
6. Grasp the water inlet hose by hand and pull it downward to see whether it is secured
7. Screw the nut on the other end of the water inlet hose into the water inlet of the washing machine to the most.
Tap
File
If the calibre of the tap
Connecting ring
is big, the connecting
ring can be taken off.
Skirt
Notices:
After installation, do not start the washing machine in haste. First open the tap to let the water press into
the water inlet hose to check whether there is any leakage in the connectors on the both ends. Sometimes it is
difficult to fix the water inlet hose due to the problem of the tap, you can ask an experienced man for help or
contact the local customer service department. When the pressure is too high, please shut the tap a little to avoid
water leakage.
Installation of the drain hose
Nip the fixing ring with hand to make it loose and engaged on the drain hose and put the drain hose into the
leading skirt of drain hose in the bottom of the washing machine to the end at the most (soak the head of the drain
hose in warm water, it will make the engagement easy), and loose the fixing ring to let it clasp the drain hose.
It had better put the outlet of the drain hose into the nearby
drainage permanently, which can save the trouble that the drain
hose has to be connected each time before use. If the drainage is far
from the washing machine, it can be solved by connection of the
drain hoses head with end to extend.
Notices:
Drain faults will be caused when the drain hose
is blocked or after the extension of the hose, it is above the
water outlet.
Locking ring
Cabinet
Inner hose
Fixing ring
Drain hose
Leading ring