Thrush Aircraft S2RHG-T65 TURBO THRUSH Maintenance Manual page 74

THRUSH AIRCRAFT, INC – MODEL S2RHG-T65 TURBO THRUSH
C. Connect the electrical leads and connector plugs at the locations noted:
1. Engine ground cable to rear of engine-driven boost pump.
2. Fuel flow transducer (if equipped).
3. Starter/generator terminal block.
4. Ignition leads at exciter box.
5. Oil temperature-sending unit.
6. Ng tach generator.
Route forward electrical harness through forward close out.
Install grommet in slot provided. Secure harness to basket
structure as previously noted. Connect harness to items as
follows.
7. Tq pressure transmitter (if equipped).
8. Np tach generator.
9. Prop beta micro switch.
10. Over speed governor prop test solenoid (Be sure to install the two ground
wires on the mounting stud.)
11. ITT harness at the T5 terminal block.
Clean terminal ends and torque the ITT harness connections
in accordance with the Engine Maintenance Manual.
D. Connect the engine controls.
1. Attach the propeller control cable housing to the forward fire seal and
connect the propeller control rod end to the propeller governor control lever.
2. Connect the fuel condition control cable rod end at the FCU condition lever.
3. Connect the power control cable rod end at the FCU power input lever.
E. Install the propeller.
F. Rig the engine controls.
G. If necessary, refer to the Engine Maintenance Manual for depreservation of the
engine oil and fuel systems.
H. Service the engine oil system.
I. Remove the cover from the compressor inlet screen.
J. Install the engine cowling.
4-10
AIRCRAFT MAINTENANCE MANUAL
* NOTE *
* NOTE *
Effective: 5/05/04