Thrush Aircraft S2RHG-T65 TURBO THRUSH Maintenance Manual page 72

THRUSH AIRCRAFT, INC – MODEL S2RHG-T65 TURBO THRUSH
After wiring harness has been removed from above items,
remove the grommet at basket assembly aft. Close out and
carefully pull the harness aft and clear of basket. Secure
harness to prevent damage until ready to re-install.
6. Ng tach generator.
7. Oil temperature sending unit.
8. Ignition leads at exciter box.
9. Starter/generator terminal block.
10. Fuel flow transducer (If equipped).
11. Engine ground cable from rear of engine driven boost pump.
M. Disconnect the engine controls.
Tag and retain all attaching control cable parts for engine
installation. Note clamp locations to facilitate control cable
installation.
1. Disconnect the propeller control rod end at the propeller governor control
lever and remove the cable from the forward fire seal.
2. Remove the prop cable from the forward fire seal.
3. Disconnect the condition lever control push-pull tube rod end at the lever on
the start control unit.
4. Disconnect the power control cable rod end at the power-input lever.
N. Remove engine mount cuffs at aft fire seal (8 locations).
O. Remove forward and rear fire seals.
P. Remove forward engine mount basket assembly.
Q. Remove the engine unit from the aircraft as follows:
1. Attach the engine sling to the engine hoisting lugs. Position a suitable hoist
directly over the engine and attach to the engine sling.
2. Raise the hoist sufficiently to take the weight of the engine.
3. Remove the cotter pins and attaching hardware, which attaches the engine
vibration, mounts to the mounting, trusses.
4. Remove the bolts and washers attaching the mounts to the engine mount
truss.
R. Hoist the engine unit clear of the fuselage nose section and install in a suitable
stand. Remove the engine sling.
4-8
AIRCRAFT MAINTENANCE MANUAL
* NOTE *
* NOTE *
Effective: 5/05/04