Electric Wiring - Delta 21CK018C24 Instruction Manual

Above100mm
The specs of the selected join drain hose should fits the running capacity of the unit.
☆ Check the smoothness of drain after installation.
☆ Check the drain state by immitting 600cc water slowly from the outlet vent or test hole.
☆ Check the drain in the state of refrigerating after installation of the electric circuit.
[ Way of immiting ]
Drain vent for repair use (plastic
stopper is included) (drain the water
in waterspout by this outlet vent)
● Warning: Before obtaining access to terminals, all supply circuits must be disconnected.

12.2 Electric wiring

1、All field supplied parts and materials must conform to local laws and regulations.
2、For electric wiring, refer to WIRING DIAGRAM attached to the unit body.
3、All wiring must be performed by a skilled technician.
4、A circuit breaker capable of shutting down power supply to the entire system and which have at
least 3 mm contact separation in each jole must be install in the fixed wiring.
5、Earth properly.
6、Wiring must conform to national laws and regulations.
7、The fixed wiring must be installed with a protector with no more that 30 mA leakage current.
8、If the supply cord is damaged, it must be replaced by the manufactory or its service agents or a
similarty qualified person in order to avoid a hazard.
Above100mm
< Immiting water from the outlet
vent terminal >
Drain hose
< Immiting water from the rest hole >
Plastic water pot (The length of the
pipe should be about 100mm.)
44
T-tie in join drain hose
Test hole cover
Test hole