Figure - Ikon IK82 User Manual

Filter Warning: Clean filter warning is
displayed after 60 hours of operation and flashes
every 1 second. You may reset the filter time and
Lamba On/Off
clear filter icon by pressing M on/off button for 3
seconds after cleaning and re-installing the filters.
Programmable options may be set while
Alarm
the motor and lamp is turned off and
Saat
timer is not set.
1- Back light brightness settings:When you press
V- button for 5 seconds, blue color percentage is
displayed on the screen. (for example: B 00 ). If
Lamba On/Off
you press V- button again, red color percentage is
displayed on the screen.
(for example: R 100 ). If you press V- button again,
red color percentage is displayed on the screen (for
example: G 10 ). The color displayed on the screen
may be set from 0 to 100 percent by pressing Tmr-
and Tmr+ buttons (it may be set rapidly by pressing
longer). When you press V- button for 5 seconds,
new color is recorded (a beep sounds) and setting
mode is turned off. To exit from setting mode without
saving, you may press Mot/off or lamp buttons.
The icon for the option currently operating on the hood shall be active and displayed in white as shown in
the figure above. Other icons shall not be displayed.
Slider screen: It shall always be active with a white color.
This screen operates with slide and drop logic. When the hood starts to operate with the 1st speed, appliance
shall be brought to 2nd speed when the screen is slid and dropped once; and this procedure shall be repeated
until the appliance reaches the required speed. The reverse of this procedure shall be applied to decrease
speed. While setting the timer and dimmer, if you press the timer ( ) inscription on the glass seven segments
shall start to flash on the digital screen (
the finger pressed on the screen, the value on the screen shall increase up to 99 with increments of 1. User
shall apply the reverse of this procedure to reduce the value. Same procedure applies for dimmer feature.
On/off Icon: When you touch this icon, hood
starts to operate, and fan icon on the digital screen
( )shall start to rotate and (
shall be activated.
Control area Variant 4
). When the user moves his/her finger slowly to the right keeping
)seven segments
13
2- Back light option: Back light is turned on as
factory default.
Optionally, back light may be turned off by pressing
V+ button for 5 seconds (a beep sounds) when the
motor and lamp are turned off and timer is not set (i.e.
hood is not operated). Press V+ button for 5 seconds
to bring the back light to always on condition.
Blue (%) Red(%)
100 100
0 100
0 0
100 0
50 100
0 100
0 0
0 100
Timer Icon: The timer icon on the digital screen
( ) shall be activated when you touch this icon.
Green(%) Color
100 Light Turquoise
100 Pistachio Green
100
Green
0
Blue
0
Purple
0
Red
0
Black and white display
10
Orange