Power Supply Cord Replacement - Viking VCSO210SS Service Manual

FAN MOTOR (BOTTOM vENTiLATiON) REMOvAL
1. Disconnect the power supply cord, and then remove the
outer case and the back plate assembly.
2. Open the door and block it open.
3. Wait for 60 seconds to discharge the high voltage
capacitors of the inverter unit.
4. Disconnect the high voltage wire from the magnetron
terminal with insulated pliers.
5. Make the terminal (metal part) of the high voltage wire
contact to the magnetron body with insulated pliers.
6. Now, the capacitors of the inverter unit are discharged.
WARNiNG: Use the pliers that the portions of their handles
are insulated completely to avoid an electric
shock.
7. Remove the bottom plate assembly, referring to
"BOTTOM PLATE ASSEMBLY REMOVAL".
1. Removal
1. Disconnect the power supply cord, and then remove the
outer case and the back plate assembly.
2. Open the door and block it open.
3. Wait for 60 seconds to discharge the high voltage
capacitors of the inverter unit.
4. Disconnect the high voltage wire from the magnetron
terminal with insulated pliers.
5. Make the terminal (metal part) of the high voltage wire
contact to the magnetron body with insulated pliers.
6. Now, the capacitors of the inverter unit are discharged.
WARNiNG: Use the pliers that the portions of their handles
are insulated completely to avoid an electric
shock.
7. Remove the bottom plate assembly, referring to
"BOTTOM PLATE ASSEMBLY REMOVAL".
8. Remove the one (1) screw holding the filter cover to the
bottom plate.
9. Straighten the tab of the bottom plate holding the filter
cover to the bottom plate.
10.Remove the filter cover from the bottom plate.
11. Remove the one (1) screw holding the grounding wire of
the power supply cord to the bottom plate.
12.Disconnect the wire leads of the power supply cord from
the noise filter and the wire harness.
13.Remove the power supply cord from the square hole of
the bottom plate.

POWER SUPPLY CORD REPLACEMENT

Cord stopper
1
Square hole
8. Disconnect the connector of fan motor from the wire
harness.
9. Remove the one (1) screw holding the left hinge
assembly to the oven cavity.
10.Remove the left hinge assembly.
11.Remove the four (4) nuts holding the intake duct sub
assembly to the oven cavity.
12.Remove the intake duct sub assembly from the oven
cavity.
13.Remove the two (2) screws holding the fan mounting
angle and the air guide sheet to the intake duct sub
assembly.
14.Remove the two (2) screws holding the fan motor to the
fan mount- ing angle.
15.Remove the fan motor from the fan mounting angle.
2. installation
1. Insert the cord stopper of the power supply
cord into the square hole of the bottom plate, referring to
the figure.
2. After inserting the cord stopper, slide it to the
right side.
3. Install the grounding wire lead of the power supply cord
to the bottom plate with the one (1) screw. And tight the
screw
4. Connect the white wire lead of the power supply cord to
the noise filter correctly, referring to "CIRCUIT
DIAGRAMS".
5. Connect the black wire lead of the power supply cord to
the wire harness, referring to "OTHER COMPONENTS"
(Page 32).
6. Reinstall the filter cover to the bottom plate with the one
(1) screw.
7. Hold the filter cover to the bottom plate by bending the
tab of the bottom plate.
8. Reinstall the bottom plate assembly to the oven.
9. Reconnect all leads removed from components during
testing.
10.Reinstall the outer case and the back plate assembly.
11. Reconnect the power supply cord after the outer case
and the back plate assembly are installed.
12.Run the oven and check all functions.
Power supply cord
Bottom plate
2
31
VCSO210SS