Viking VCSO210SS Service Manual page 27

11. Remove the ten (10) screws fixing the bottom plate
assembly (bottom face) to the left heat shield plate, the
right heat shield plate, the left hinge assembly, the right
hinge assembly and the front plate of the oven (Fig 1).
12. Remove the one (1) screw holding the AC Fan Assembly
(Fig 2).
13. Disconnect the wiring harness at the Magnetron, Fan
Thermo, Convection Motor, AC Fan and Convection
Thermo (Fig 3).
14. Disconnect the Ventilation Fans connectors, Stirrer
Motor, Cooling Fan, and Ventilator Fan (Fig 4).
15. Lift the bottom plate assembly to remove it from the
oven body and lay it to the side of the unit. This will alow
some wires to stay connected (Fig 5).
NOTE: In order to prevent the fan duct covering around the
magnetron terminal from hitting the terminal, slightly
shift the bottom plate assembly toward the left hinge
assembly and then lift the bottom plate assembly.
AC Fan
motor
assembly
screw.
Take care not
to break the
assembly
Disconnect
the stirrer
motor, the
cooling fan,
and the
ventilator
fan.
FIG 2
FIG 4
Mounting screws of bottom plate assembly
Disconnect
wiring
harness at:
Magnetron
Fan thermo
Convention
motor
AC Fan
Convection
thermo
27
VCSO210SS
FIG 1
FIG 3
FIG 5