Joyner JNSZ800DL Owner's Manual page 68

Perform this pre-drive inspection everyday before driving vehicle. If not performed,
serious damage to the vehicle or personal injury may result.
1. Check for Engine Oil Level. Check for transmission Oil Level. Check for leaks, add
oil if required.
2. Check the coolant. Check for leaks, add the coolant if required.
3. Check for Fuel Level. Add fuel as necessary and do not overfill. Check for leaks.
4. Check for Brakes. Depress the brake pedal several times, and then check for proper
brake pedal free play. Make sure there is no brake fluid leakage. Adjust if necessary.
5. Check the clutch cable, Assure the cable snaps back and has a smooth operation.
Ensure the clutch can operate smoothly. Adjust if necessary, or replace the clutch if
necessary.
6. Check Tires. Check tires condition and pressure. The pressure on both Front and Rear
tire is 12psi.
7. Check Throttle. Check for smooth operation. Ensure the throttle "snaps" back to idle.
8. Check Engine Stop key. Perform engine stop key test. Repair as necessary.
9. Check all Nuts, Bolts, and fasteners. Check wheels to see that all axle nuts and lug
nuts are tightened properly. Check and tighten as necessary all other fasteners to
specified torque.
10. Check Roll Cage Bars. Ensure all protective roll cage bars are in place before
operating the ATV.
12. Check Brake Light. Check for proper operation.
13. Check Wheels. Check for tightness of wheel nuts and axle nuts; check that axle nuts
are secured by cotter pins.
14. Check Steering. Check for free operation and for any unusual looseness in any area.
Always follow rules for safe operation and wear a helmet.
C. Passengers
The vehicle allows for two riders only.
Combined maximum weight of driver
and the passenger should not exceed 180kg
or 400Ibs.
D. Seat Adjustment
The seat must always be securely
fastened in the position which best
allows the operator control of the foot
pedals, steering wheel, and the remote
stop key.
a. Pull seat adjustment handle upward to disengage seat slide.
b. Move seat to desired position.
Fig. 4
19
OPERATION