Flavel FWERN0MN Installation And Maintenance Instructions Manual page 20

4.6 REMOVAL / REPLACEMENT OF THE LIGHTBULBS
a) Isolate the appliance from the electricity supply.
b) Remove the coal form as shown on page 16, Fig 7.
c) Remove the bulbs from the bayonet fitting and replace with a new one
of the correct specification, as shown below in Fig. 13
Fig. 13
Bayonet Fitting
PARTS SHORTLIST
Replacement of any other parts must be carried out by a competent person such
as a CORGI registered gas installer or competent electrician.
The part numbers of the user replaceable parts are as follows, these are available
from specialist spares stockists whose details can be found on our web site,
www.cfm-europe.com, in the 'stockist' section.
Ceramic Plaques Set
Gas valve
ODS Pilot Assy. (NG)
Control Knob
Injector
Mains Cable
Due to our policy of continual improvement and development the exact
accuracy of illustrations and descriptions contained in this book cannot be
guaranteed.
Supplied By www.heating spares.co Tel. 0161 620 6677
FC-P079648
B-63250
B-48360
B-63520
B-63240
B-77270
20