Operation And Important Riding Points; Starting The Engine - Yamaha Cygnus-X XC125 Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

OPERATION AND IMPORTANT RIDING POINTS
Read the Owner's Manual carefully
to become familiar with all controls.
If there is a control or function you
do not understand, ask your Yamaha
1
dealer.
2
WARNING
Failure to familiarize yourself with
the controls can lead to loss of
3
control, which could cause an ac-
cident or injury.
4
TIP
5
This model is equipped with a lean
angle sensor to stop the engine in
6
case of a turnover. To start the en-
gine after a turnover, be sure to turn
7
the main switch to "OFF" and then to
"ON". Failing to do so will prevent the
engine from starting even though the
8
engine will crank when pushing the
start switch.
9
EAU15951

Starting the engine

NOTICE
See page 5-3 for engine break-in
instructions prior to operating the
EWA10271
vehicle for the fi rst time.
In order for the ignition circuit cut-off
system to enable starting, the sides-
tand must be up.
See page 3-12 for more information.
1. Turn the key to "ON".
EAU45310
2. Close the throttle completely.
3. Start the engine by pushing the
start switch while applying the
front or rear brake.
If the engine does not start, re-
lease the start switch, wait a few
seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 5 seconds on any
one attempt. If the engine does
not start with the starter motor, try
using the kickstarter.
EAUT1864
NOTICE
ECA10250
For maximum engine life, never ac-
celerate hard when the engine is
cold!
5-1
EAU15943 EAU15943
ECA11042