Yamaha Cygnus-X XC125 Owner's Manual page 46

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
ZAUM00**
3
1. Engine oil drain bolt A
4
5
6
7
ZAUM00**
1. Engine oil drain bolt B
8
4. Clean the oil strainer with solvent,
and then check it for damage and
9
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, spring,
O-ring and engine oil drain bolts,
and then tighten the drain bolts to
the specifi ed torque.
Tightening torque:
Engine oil drain bolt A:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
Engine oil drain bolt B:
1
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
TIP
Make sure that the O-ring is properly
seated.
7. Refi ll with the specifi ed amount of
the recommended engine oil, and
then install and tighten the engine
oil fi ller cap.
Recommended engine oil:
1
See page 8-1.
Oil change quantity:
0.9 L (0.95 US qt, 0.79 Imp.qt)
NOTICE
●
Do not use oils with a diesel
specifi cation of "CD" or oils of
a higher quality than specifi ed.
In addition, do not use oils la-
●
8. Start the engine, and then let
9. Turn the engine off, and then
10. Reset the oil change tripmeter.
TIP
If the engine oil is changed before
the oil change indicator flashes (i.e.
before the periodic oil change interval
has been reached), the oil change
ECA11670
tripmeter must be reset after the
oil change for the next periodic oil
change to be indicated at the correct
time.
6-11
beled "ENERGY CONSERVING
II" or higher.
Be sure no foreign material en-
ters the crankcase.
it idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the en-
gine off and check for the cause.
check the oil level and correct it if
necessary.
(See page 3-3 for reset proce-
dures.)
EAU1722A