Wireless Security - TP-Link TD-W8970 User Manual

Step 2: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected
Step 3: When the WPS LED is on, the client device has successfully connected to the modem
Step 4: Refer back to your client device or its documentation for further instructions.

Note:
1) The WPS LED on the modem router will light green for five minutes if the device has been
successfully added to the network.
2) The WPS function cannot be configured if the Wireless Function of the modem router is
disabled. Please make sure the Wireless Function is enabled before configuring the WPS.

4.8.3 Wireless Security

Choose menu "Wireless"" Wireless Security", you can configure the security settings of your
wireless network.
There are three wireless security modes supported by the modem router: WPA/WPA2 – Personal,
WPA/WPA2 – Enterprise, WEP (Wired Equivalent Privacy).
Disable Wireless Security: If you do not want to use wireless security, check this radio

button. But it's strongly recommended to choose one of the following modes to enable
security.
WPA/WPA2-Personal - It's the WPA/WPA2 authentication type based on pre-shared

passphrase. The modem router is configured by this security type by default.
•
Downloaded from www.Manualslib.com
TD-W8970 300Mbps Wireless N Gigabit ADSL2+ Modem Router User Guide
Setup process.
router.
Authentication Type: You can choose the type for the WPA/WPA2-Personal security on
manuals search engine
Figure 4-38
45