TP-Link TD-W8970 User Manual page 53

Step 1: Press the WPS button on the back panel of the modem router, as shown in the following
You can also keep the default WPS Status as Enabled and click the Add device button in Figure
4-35, then Choose "Press the WPS button of the new device within the next two minutes" and
click Connect. (Shown in the following figure)
Step 2: Press and hold the WPS button of the client device directly.
Step 3: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup
Step 4: When the WPS LED is on, the client device has successfully connected to the modem
Refer back to your client device or its documentation for further instructions.
II. Enter the client device's PIN on the modem router
Use this method if your client device has a Wi-Fi Protected Setup PIN number.
Step 1: Keep the default WPS Status as Enabled and click the Add device button in Figure
Step 2: Enter the PIN number from the client device in the field on the above WPS screen. Then
Step 3: "Connect successfully" will appear on the screen of Figure 4-37, which means the
III. Enter the modem router's PIN on your client device
Use this method if your client device asks for the modem router's PIN number.
Step 1: On the client device, enter the PIN number listed on the modem router's Wi-Fi Protected
Downloaded from www.Manualslib.com
TD-W8970 300Mbps Wireless N Gigabit ADSL2+ Modem Router User Guide
figure.
process.
router.
4-35, then the following screen will appear.
click Connect button.
client device has successfully connected to the modem router.
Setup screen. (It is also labeled on the bottom of the modem router.)
manuals search engine
Figure 4-36
Figure 4-37
44