installing your camera
SCP-3120VH
1.
Use the provided L-shaped wrench to loosen 4 screws counter clockwise, which will
help removing the housing.
HOUSING
MAIN-FRAME
2.
Fix the housing to the NP 1.5" tapped pipe, wall mount (SBP-302W) or ceiling mount
(SBP-302P) by turning it clockwise. For waterproofness and lock between the two
component parts, use the Tefl on tape to wrap them around.
PIPE or MOUNT
HOUSING
40_ installing your camera
SCREW
SCREW
PIPE or MOUNT
NP 1.5' TAP
HOUSING
3.
Secure the safety wire (attached to the product) to the housing as shown. (For details
about the cable connection, refer to the "Camera Wiring Interface Board" section in this
manual.)
SAFETY WIRE
4.
Arrange the cables inside the housing lest they be damaged or stuck in, and use the L-
shaped wrench to tighten 4 screws to the housing. To ensure waterproofness, this step
needs your special care. Otherwise, the gasket on the outer side of the product may be
loose or just stuck in.
HOUSING
MAIN-FRAME
GASKET
SAFETY WIRE
SCREW
English _ 41
English