Making The Connections; Audio Sources; Satellite Speakers, Recording Unit And Second Pa System; Connection To The Mains - Omnitronic ACS-510 User Manual

Table of Contents

Available languages

MAKING THE CONNECTIONS

Switch off the PA system and the units to be connected before making or changing the connections.

As signal source, microphones and audio units with line level (e.g. smartphone, MP3 player, mixer) can be

connected.

Connect microphones to the input jacks of channels CH 1 [10] and CH 2 [11]. Set the corresponding

MIC/LINE selector switch [3] to position MIC.

There are several input jacks available for audio units with line level:

• Use input CH 1 [101] for units with mono output (e.g. instrument preamplifiers) and input CH 2 [11] for

units with stereo output (e.g. mixer). Set the corresponding MIC/LINE selector switch [3] to position

LINE.

• Inputs CH 3 [12] and AUX [4] are also designed for stereo signals. The RCA jacks [12] will be switched

off when the 3.5 mm jack [4] is connected.

Connect the satellite speakers to the SPEAKER OUT jacks as described in chapter 5. Set the SETUP

selector switch [91] accordingly.

The OUT jacks [13] can either be used to route the input signal of channel CH 2 or the master signal to

a recording unit or a further active speaker system. The MODE selector switch [8] determines which

output signal is present.

For larger PA applications, two ACS-510 systems can be combined. Connect the LINK IN/OUT jacks

[14] of both units with a stereo jack cable. The first unit serves as the signal source for the second unit.

Thus, use the mixer channels of the first unit as usual and set all gain controls [7] to minimum at the

second unit.

Finally, connect the supplied power supply cable to the corresponding input and the mains plug to an outlet

(AC 230 V, 50 Hz). The device can also be operated with AC 115 V, 60 Hz ~. For this purpose, set the

voltage selector switch to the 115 V position.

Table of Contents