Table of Contents
Advertisement
TROUBLE CONDITIONS (Continued)
4. SYSTEM LO BAT
* T
he beeping that
accompanies a low
battery display (items
4 and 5) can be
5. LO BAT + zone descriptor
stopped by entering
an OFF sequence
(code + OFF)
6. Rcvr Jam
** Not all systems use
wireless transmitters.
7. MODEM COMM
8. AC LOSS is displayed
9. Busy-Standby (or dI)
10
11. Long Rng Trbl (or bF)
12. BELL FAILURE
(or BAT with no zone No.)
(or BAT with zone No.)
(or CHECK 90)
(or CC)
(or NO AC)
OPEN CIRCUIT (or OC)
(or CHECK 70)
– 30 –
Indicates that a low system battery condition exists, and
accompanied by a once-per-minute "beeping"* at the
Keypad. CALL FOR SERVICE IMMEDIATELY.
Indicates that a low battery condition exists in the wireless
transmitter** displayed, and accompanied by a once-per-
minute "beeping"* at the Keypad. CALL FOR SERVICE.
Wireless part of the system is experiencing RF interference
which may impede reception from wireless sensors.**
Indicates that the control is on-line with the central station's
remote computer. The control will not operate while on-line.
Wait a few minutes. The display should disappear.
The system is operating on battery power only. If only some
lights are out on the premises, check circuit breakers and
fuses and reset or replace as necessary. CALL FOR
SERVICE if AC mains cannot be restored to the system.
If this remains displayed for more than 1 minute, system is
disabled. CALL FOR SERVICE AT ONCE.
The keypad is not receiving signals from the control.
If programmed, back-up Alternative Media communication
has failed. CALL FOR SERVICE IMMEDIATELY.
Indicates that the wiring connection to the external sounder
is at fault (open or shorted). Accompanied by "beeping" at
the touchpad. CALL FOR SERVICE IMMEDIATELY.
Advertisement
Table of Contents
