Advertisement

Quick Links

73-1947-250
5/03
World of Disney
Ready-to-Run Train Set
Owner's Manual
CAUTI O N—ELECTRI C TOY
NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH
ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING
HANDLI N G AND USE TO REDUCE THE RI S K OF ELECTRI C SHOCK.
TRANSFORMER RATINGS—I N PUT:120 VAC; 60 HZ ONLY.
AC OUTPUT:18 V; 80 VA
©Disney

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6-31947 and is the answer not in the manual?

Questions and answers

Summary of Contents for Lionel 6-31947

  • Page 1 73-1947-250 5/03 World of Disney Ready-to-Run Train Set Owner’s Manual CAUTI O N—ELECTRI C TOY NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLI N G AND USE TO REDUCE THE RI S K OF ELECTRI C SHOCK. TRANSFORMER RATINGS—I N PUT:120 VAC;...
  • Page 2 In the event that such conditions exist, the transformer should not be used until properly repaired. The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ®...
  • Page 3: Table Of Contents

    • Reefer • Owner’s Manual • Square window caboose • Service Center list • CW-80 Transformer with • Instruction video accessory wire • Lionel RailRoader Club flyer • Three straight FasTrack track • Catalog sections • Eight curved FasTrack track sections...
  • Page 4: Track Layout

    Track layout Building your Lionel layout our set comes with eight curved, three straight, and one terminal section of track. Figure 1 provides some examples of layouts that you can build with these track sections. By adding more FasTrack track sections, you can create an endless number of exciting track arrangements for more fun, action, and variety.
  • Page 5: Controller Operations

    • Parents should periodically inspect this product for potential hazards and, if necessary, have them repaired by an authorized Lionel Service Center. In the event that such a condi- tion exists, the transformer should not be used until it has been properly repaired.
  • Page 6: Wiring Your Cw-80 Transformer

    4. If you need to power an accessory (available separately at your authorized Lionel dealer), connect the accessory to the ACCESSORY thumbscrew terminals. Use the accessory wire included with the CW-80 Transformer. 5. Plug the CW-80 Transformer into your wall outlet (120 volts).
  • Page 7 Controller operations Wiring your CW-80 Transformer (continued) FasTrack terminal section Spade-shaped connector TRACK ACCESSORY 120/60z 0~18VAC 0~18VAC Notch Figure 3. Controller connections...
  • Page 8: Advanced Connections: Powering Two Isolated Blocks With Two Transformers

    Controller operations Advanced connections: powering two isolated blocks with two transformers s you expand your layout, you may decide to create two isolated blocks of track. Trains in each block are controlled by separate transformers. Before you operate your trains on this type of layout, be sure that your transformers are in phase.
  • Page 9: Experiencing The Features Of The Cw-80 Transformer

    Controller operations Experiencing the features of the CW-80 Transformer Refer to Figure 5 on page 10 for the location of the Transformer features listed in this section. THROTTLE Push the throttle forward to increase track power. The markings on the throttle approxi- mate the percentage of full power.
  • Page 10: Experiencing The Features Of The Cw-80 Transformer

    CW-80 is on. Whistle Activates the whistle or horn sound Throttle effect in Lionel locomotives. Press Controls your locomotive’s speed. Throw the throttle for- WHISTLE to begin the sound; release ward to increase locomotive speed, backward to slow it the button to end it.
  • Page 11: Setting The Accessory Output

    — from crossing signals to coal and lumber loaders — available at your authorized Lionel dealer. When you are ready to operate your new accessory, the CW-80 Transformer allows you to choose how much power your accessory receives with programmable accessory output.
  • Page 12: Train Operations

    Figure 6. Drawbar connection Power up your locomotive with your transformer. Your locomotive is designed to operate on 7-15 volts alternating cur- rent. Virtually all Lionel and Lionel-compatible alternating-current transformers are suitable. Note! Do not power your locomotive with direct current (DC) transformers.
  • Page 13: Reverse Unit Procedure

    Reverse unit procedure he electronic reverse unit inside your thrown to the OFF position, the locomotive Lionel locomotive acts like the transmis- will be locked in the next mode of operation sion in a car. When you apply power to the in the sequence.
  • Page 14: Tire-Traction

    See rubber traction tires to enhance tractive your authorized Lionel Service Center for effort, allowing your locomotive to pull assistance. Refer to the Service Center list that many cars at once.
  • Page 15: Maintaining And Servicing Your Set

    Maintaining and servicing your set Lubricating your 4-4-0 steam locomotive elp your Lionel General 4-4-0 locomo- avoid getting grease or oil on the locomo- tive lead a long and productive life on tive’s wheels, contact rollers, or your track. your railroad by maintaining it properly.
  • Page 16: Adding Smoke Fluid To Your Locomotive

    Always keep a small amount of smoke The smoke generator requires the periodic fluid in the smoke generator; the generator’s addition of Lionel smoke fluid in order to element can become damaged if operated function. Pierce the tube end with a pin, then without fluid.
  • Page 17: Replacing Your Locomotive's Lamps

    Refer to Figure 12. Next, slide that the flat spring below the lamp makes the lamp back and remove it from the socket. contact with the base of the lamp. Replace the expired lamp with Lionel part Lantern housing Clip Lionel part no.
  • Page 18: Replacing Your Square Window Caboose Lamp

    4. Pull the lamp straight up and out of the socket. Replace it with Lionel lamp no. 600-8352-311, available at your authorized Lionel Service Center or Lionel Service.
  • Page 19: Troubleshooting

    Maintaining and servicing your set Troubleshooting No lights or operation Be sure that the CW-80 Transformer is plugged in and the wires are connected. Train runs, but WHISTLE, BELL, and DIRECTION buttons do not work Check track connections. The track must be connected to the “A” and “U” terminals on the Transformer.
  • Page 20: Limited Warranty/Lionel Service

    Center, together with proof of original purchase above instructions carefully before returning any will, at the option of Lionel L.L.C., be repaired or merchandise for service. You may choose to have replaced, without charge for parts or labor. In the...

Table of Contents